Call us at (661) 257-4060

Products | Equipment | Finishing Equipment | Bullnose Trimmer
Bullnose Edge Trimming System Print

Quickly, easily and precisely trim bullnose edges on deck castings.

Features/Benefits:

  • Dramatically reduces previously time-consuming finishing process with better result.
  • Follows contours of top surface for uniform bullnose profile across entire length.
  • Prevents narrowing when used on bowed or warped decks.
  • Two versions - 120V (for U.S.) or 220V
Image_0006
Image_0001
The saw with built-in guide (above), and optional trimming table (at right).
 
Note: Trim Table is a recommended option for added convenience and speed. The table measures 8' L x 20" W x 30" H.
 
This system simplifies trimming of bullnose edges on decks of all sizes, and produces straight, machine cuts that minimize labor costs for this operation.
An optional 8’ trim table properly positions the deck edges for cutting. The top edge is easily replaceable wood if excessive number of blade cuts destroy the original.
 
Using it is simple. Set the deck on the trim table, with the bullnose edges hanging over. Position the saw with the guide attachment on the deck surface, and trim the excess bullnose edge flash material off along an entire surface. Repeat on each side.

The finished deck requires minimal cleanup afterwards with a simple sanding block to smooth any remaining protrusions.
 
 


Image_0003
Untrimmed deck casting is positioned on trim table. Custom length or size tables are available upon request.
Image_1
The saw (with integral guide) is positioned for the cut by placing the saw on the front edge of the bullnose contour. The guide ensures that the saw is positioned properly, and that the resulting cut will be uniform along the entire run.
Image_0005
Start the cut and pull the saw towards you, until the entire length has been cut.
Image_00032
Repeat for each deck edge.
 
Image_0004
The result is a neat, uniform and evenly cut bullnose bottom edge along the entire run - done in seconds!
Image_0002
The resulting cut is a consistant, uniform depth from the top surface of the deck - requires little if any finishing effort.

The Bullnose Edge Trimming System from Gruber will produce better cuts in a fraction of the time – saving you time and money!



Order Information
The Bullnose Edge Trimming System is comprised of the following items:

  • Bullnose Trim Saw - Worm Drive Saw with integral Cutting Guide, 120V (for U.S.) - #SAWBN120
  • Bullnose Trim Saw - Worm Drive Saw with integral Cutting Guide, 220V - #SAWBN220
  • Optional Bullnose Edge Trim Table (8' L x 20" W x 30" H) - #190052
 
© 2011 by Gruber Systems, Inc. All rights reserved. Subject to change without notice.