| Trim That Bullnose Edge in a Flash! |
 |
 |
|
Saving time, labor, and bringing consistency to a task are all great reasons to consider a change. The Bullnose Edge Trimming System meets all these criteria. The Bullnose Edge Trimming System makes quick work of expertly trimming the flashing off a bullnose edge casting. The system includes a worm-drive saw, a deck guide fixturing attachment, and an optional trim table specially designed for use with the system.
The system simplifies trimming bullnose edges on decks of all sizes, and produces straight machine cuts that minimize labor costs for this operation… And it’s all as simple as 1-2-3: 1. Set the deck on the trim table, with the bullnose edges handing over. 2. Position the saw with the guide attachment on the deck surface, and trim the excess bullnose edge flash material off along an entire surface. Repeat on each side. 3. The finished deck requires minimal cleanup afterward using a simple sanding block to smooth any remaining protrusions. The Bullnose Edge Trimming System from Gruber will produce better cuts in a fraction of the time, saving you time and money!… |
